OBD2 code U0045: Vehicle Communication Bus B (-) shorted to Bus B (+)
The two lines of differential bus B are shorted together.
Detected Root Component
Network Component
Observed Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Possible Causes
- Bus lines shorted together
- Gateway module routing CAN messages incorrectly
- CAN terminating resistor (120 Ω) drifted out of spec
Tools Required
Interactive Diagnostic
Answer each question to calculate your diagnostic score.
No steps available.
Diagnostic Result
Score threshold guide
Was this diagnostic helpful?
Parts likely to be the cause (Moteur (général))
Moteur (général)
Photo d'illustration : Moteur (général)
© DTC-Logic.com
Click on an image to enlarge
Frequently asked questions about code U0045
What does code U0045 mean? ▾
OBD2 code U0045: Vehicle Communication Bus B (-) shorted to Bus B (+). The two lines of differential bus B are shorted together.
What are the symptoms of code U0045? ▾
Code U0045 may cause: Multiple warning lights may illuminate, Affected modules may go into limp mode or shut down, Specific functions inoperative depending on module, Diagnostic tools may show communication faults. The intensity of these symptoms varies depending on the vehicle and driving conditions.
What causes code U0045? ▾
The most common causes of code U0045 are: Bus lines shorted together, Gateway module routing CAN messages incorrectly, CAN terminating resistor (120 Ω) drifted out of spec. A proper OBD2 diagnostic will pinpoint the exact cause.
Is it serious to drive with code U0045? ▾
Yes, code U0045 is critical (Critical). Avoid driving and consult a professional promptly to prevent major damage.
How do I fix code U0045? ▾
Start by reading the code with an OBD2 scanner, then follow the interactive decision tree on this page. Priority causes to check: Bus lines shorted together, Gateway module routing CAN messages incorrectly, CAN terminating resistor (120 Ω) drifted out of spec. Difficulty: Medium · Estimated time: 30-60min.