OBD2 code P2902: Generic powertrain code
Generic powertrain code (SAE J2012).
Detected Root Component
Powertrain Component
Observed Symptoms
- Check engine light on (MIL)
Possible Causes
- Faulty sensor or actuator in the affected circuit
- Damaged wiring or connector
- Corroded connector
- Faulty control module (rare)
Tools Required
Interactive Diagnostic
Answer each question to calculate your diagnostic score.
No steps available.
Diagnostic Result
Score threshold guide
Was this diagnostic helpful?
Parts likely to be the cause (Moteur (général))
Moteur (général)
Photo d'illustration : Moteur (général)
© DTC-Logic.com
Click on an image to enlarge
Frequently asked questions about code P2902
What does code P2902 mean? ▾
OBD2 code P2902: Generic powertrain code. Generic powertrain code (SAE J2012).
What are the symptoms of code P2902? ▾
Code P2902 may cause: Check engine light on (MIL). The intensity of these symptoms varies depending on the vehicle and driving conditions.
What causes code P2902? ▾
The most common causes of code P2902 are: Faulty sensor or actuator in the affected circuit, Damaged wiring or connector, Corroded connector, Faulty control module (rare). A proper OBD2 diagnostic will pinpoint the exact cause.
Is it serious to drive with code P2902? ▾
Code P2902 has moderate severity (Warning). Short-term driving remains possible, but a prompt check is recommended to prevent worsening.
How do I fix code P2902? ▾
Start by reading the code with an OBD2 scanner, then follow the interactive decision tree on this page. Priority causes to check: Faulty sensor or actuator in the affected circuit, Damaged wiring or connector, Corroded connector, Faulty control module (rare). Difficulty: Medium · Estimated time: 30-60min.